Set advertise=100M-full,1000M-half,1000M-full comment=" A&A PPPoE line" disabled=no interface="A&A Eth" keepalive-timeout=10 max-mru=1492 max-mtu=1492 name="A&A PPPoE Line 2" password=************ profile=AAISP2 service-name=AAISP2 Duplicate these rules and adjust the "nth=" parameters if bonding more than 2 lines. # This just sets the name of ethernet interfaces and is included solely so that later interface names make sense. # of lines selected for each IP address block in. # Note that this config only defines UPSTREAM traffic bonding downstream bonding is configured by adjusting the number # more routes, and by changing the "nth" parameter of the mangle rules. More can be bonded by adding more PPPoE-Client interfaces, more firewall/mangle rules, # This config includes an odd third route rule which I can't explain, but I found that throughput broke when it was removed. # Ports ether3, ether4 and ether5 are bridged into an interface named "LAN", which is where all local traffic would # In my setup, one VDSL modem is connected directly to ether2, while the other goes via my core network switch on ether3. # Based on a Mikrotik RouterBoard RB450G. # Note: this can't be used directly, but is a good starting point.
0 Comments
Leave a Reply. |